Figure 53 Link Aggregation Control Protocol: Configuration; Table 35 Link Aggregation Control Protocol: Configuration - ZyXEL Communications ES-4124 User Manual

ES-4124 User's Guide

Figure 53 Link Aggregation Control Protocol: Configuration

The following table describes the labels in this screen.

Table 35 Link Aggregation Control Protocol: Configuration

LABEL
Link Aggregation Control Protocol
Active
System
Priority
Group ID
Active
Dynamic
(LACP)
122
DESCRIPTION
Select this checkbox to enable Link Aggregation Control Protocol (LACP).
LACP system priority is a number between 1 and 65,535. The switch with the lowest
system priority (and lowest port number if system priority is the same) becomes the
LACP "server". The LACP "server" controls the operation of LACP setup. Enter a
number to set the priority of an active port using Link Aggregate Control Protocol
(LACP). The smaller the number, the higher the priority level.
The field identifies the link aggregation group, that is, one logical link containing
multiple ports.
Select this option to activate a trunk group.
Select this check box to enable LACP for a trunk.
Chapter 15 Link Aggregation