Stiga MP 84 Series Operator's Manual page 238

6. Refit the extension tube (fig. 28.A) on the
support (fig. 28.C) before topping up the oil.
7. Clean up any spills.
IMPORTANT Hand the spent
oil over to a disposal facility in
accordance with local provisions.
7.4 ANTI-CHIPPING WHEELS
The different heights of the wheels allow
you to maintain a safe distance "H"
between the cutting-means assembly
and the ground (fig. 17.A, fig. 18.A).
Adjust the position of the anti-chipping wheels
according to how irregular the ground is.
This should always be performed on
both wheels, positioning them at the same
height WITH THE ENGINE OFF AND
CUTTING MEANS DISENGAGED.
a. for models with side discharge only
To change the position:
1. unscrew and remove the screw (fig. 17.B)
2. reposition the wheel (fig. 17.A) with
the spacer (fig. 17.C) inside the
hole at the desired distance
3. fully tighten the screw (fig.17.B)
onto the nut (fig. 17.D).
b. for models with rear collection only
To change the position:
1. unscrew the nut (fig. 18.B) and
extract the pin (fig.18.C).
2. reposition the wheel (fig. 18.A)
in the desired position
3. reassemble the pin (fig. 18.C), making
sure the pin (fig. 18.C) head is facing
toward the inside of the machine
4. then tighten the nut completely (fig. 18.B).
7.5 CLEANING
Clean thoroughly following the instructions
below every time it is used.
7.5.1 Cleaning the machine
• Clean the outside of the machine washing
the plastic parts of the bodywork with a
damp sponge using water and detergent,
taking care not to wet the engine, the
electrical parts or the electronic circuit
board located under the dashboard.
• To reduce fire hazards, keep the
engine, silencer, battery compartment
and petrol storage area free of grass,
leaves, or excessive grease.
IMPORTANT Never use hose-nozzles or harsh
detergents for cleaning the body and engine!
IMPORTANT Do not wash the
transmission system when it is hot.
Never use pressure lances to wash the
transmission system.
7.5.2 Cleaning the discharge chute (for
rear collection models only)
If the discharge chute is clogged:
1. remove the grass catcher or the
rear discharge guard;
2. remove the grass cuttings; you can reach
them from the channel discharge opening.
7.5.3 Cleaning the grass catcher (for
rear collection models only)
1. Empty the grass catcher
2. Shake it to remove grass
cuttings and soil residue
3. Replace the grass catcher and clean
the interior of the cutting-means
assembly (par. 7.4.4-a), now remove
the grass catcher, empty and rinse it,
then place it where it can dry quickly.
7.5.4 Cleaning the cutting-
means assembly
Clean the cutting-means assembly thoroughly
to remove any grass remains or debris.
Keep people or animals away from
the surrounding area when cleaning
the cutting-means assembly.
a. Cleaning the interiors
When washing the inside of the cutting-
means assembly and the discharge chute,
the machine must be on firm ground with:
– the grass catcher or the rear
discharge guard mounted in place
(for rear collection models only)
– the side discharge chute mounted (for
models with side discharge only);
– the operator seated;
– the cutting-means assembly in position «1»;
– the engine running
– the transmission in neutral
– the cutting means engaged
• Connect a water hose to each of the pipe
fittings (fig. 29.A; fig. 30.A) one at a time
and run water through each one for a few
minutes, with the cutting means moving.
EN - 17