Stiga MP 84 Series Operator's Manual page 241

8.4 ELECTRONIC CIRCUIT BOARD
The electronic circuit board is a component
fitted below the dashboard which
manages all machine safety devices.
8.4.1 Electronic circuit board
protection device (for rear
collection models only)
• The electronic circuit board is located
below the dashboard and fitted with a
self-setting protection which breaks the
circuit if there is a fault or short circuit
on the electrical system (chap. 14).
8.4.2 Electronic circuit board protection
fuse (for side discharge models only)
• The electronic circuit board is located below
the dashboard and fitted with a fuse which
breaks the circuit if there is a fault or short
circuit on the electrical system (chap. 14).
8.5 REPLACING A FUSE
The machine is fitted with fuses (fig. 41.A) with
different capacities and functions. Specifically:
– 10 A fuse = protects the main and power
circuits of the electronic circuit board.
When it blows, the machine stops and
the dashboard light switches off (for rear
discharge models only (par. 5.11)
– 25 A fuse = protects the battery
recharge circuit. When it blows, the
battery gradually runs down and the
machine will have problems starting.
The fuse capacity is indicated on the fuse.
IMPORTANT A blown fuse must always be
replaced by one of the same type and ampere
rating, and never with one of another rating.
If you are unable to understand why it
has blown , contact Your Dealer.
8.6 REPLACING BULBS
8.6.1 Type "l" - Incandescent light bulbs
• The bulbs (18W) have a bayonet fitting
and are installed in the bulb holder
which can be taken out by turning it
anti-clockwise with pliers (fig. 42).
8.6.2 Type "ll" - LED light bulbs
• Loosen the lock nut (fig. 42.A) and
remove the connector (fig.42.B).
Remove the LED illuminator (fig. 42.C),
secured by screws (fig. 42.D).
8.7 REAR AXLE
• This is a sealed single unit that does not
require maintenance. It is permanently
lubricated and its lubricant does not
need changing or topping up.
9. STORING THE MACHINE
When you intend to put your machine
away for more than 30 days:
1. Wait for the engine to cool
2. Disconnect the battery cables and
store it in a cool and dry place.
3. Empty the fuel tank (par. 7.2.2) and follow
all the instructions in the engine manual.
4. Clean the machine thoroughly.
5. Check the machine for any
damage. If necessary, contact the
authorised assistance centre.
6. Store the machine:
– with the cutting-means assembly lowered
– in a dry place
– protected from inclement weather
– and covered with a sheet where
possible (par. 15.4)
– in a place where children cannot get to it
– making sure that keys or tools used
for maintenance are removed.
Before starting to use the machine again:
• check that there are no fuel leaks from
the tubes, fuel stopcock or carburettor.
• prepare the machine as described in
chapter "6. Using the machine" .
EN - 20