Siemens KION Service Manual page 93

KION / KION-i
Connecting a Recorder and/or a
Laser Printer to the KION / KION-i
The KION / KION-i workstation can be connected to
an R 50 / R 50-N Recorder and to a Laser Printer.
Note: R 50 Recorder can only be used on KION
workstations equipped with a CPS Network PCB,
i.e. KION workstations with S/N 03645 or lower.
For units equipped with a IDS Network PCB, i.e.
KION / KION-i workstations with S/N 03646 or higher,
an R 50-N Recorder must be used.
KION / KION-i as a stand-alone unit
The KION / KION-i workstation, as a stand-alone unit,
can be connected to an R 50 / R 50-N Recorder and
to a Laser Printer.
Note: With KION / KION-i as a stand-alone unit,
R 50-N cannot be connected at the same time as a
Laser Printer. The same port (X14) is used.
For an R 50-N Recorder or a Laser Printer:
• Connect with an Ethernet Crossover cable to the
Ethernet port (X14).
• Configure the CPS / IDS for Recorder and/or for
Laser Printer. Refer to section "Configuring the
CPS / IDS" in this chapter.
For an R 50 Recorder:
• Connect with a Recorder cable to the R 50 recorder
port (X13).
• Configure the CPS / IDS for Recorder. Refer to
section "Configuring the CPS / IDS" in this chapter.
E382 E392E 061 01 02 02
KION / KION-i in a network
The KION KION-i workstation, as a node in an I
N , can be connected to an R 50-N Recorder
ETWORK
and to a Laser Printer.
• Connect the R 50-N Recorder and/or the Laser
Printer to the I
• Connect the KION / KION-i to the I
via the Ethernet port (X14).
• Configure the CPS / IDS for Recorder and/or for
Laser Printer. Refer to section "Configuring the
CPS / IDS" in this chapter.
For connection of a R 50 Recorder, refer to "KION as
a stand-alone unit" above.
Printing the Diagnostic Log
The path to print the KION Monitor Diagnostic Log is:
Menu / Monitor Setup / Biomed / Logs / Print log
Siemens-Elema AB
Service procedures
N .
NFINITY ETWORK
NFINITY
NFINITY
N
ETWORK
5
5 - 21