Siemens KION Service Manual page 90

Service procedures
5
5 - 18
SDC-SW
The SDC-software is stored in the Surgical Display
Controller (SDC) inside the D
There are two versions of the KION D
• KION D V
UO IEW
• KION D V
UO IEW
Both versions uses the same SDC-SW.
A PC and a download cable must be used when
installing the SDC-SW. Note that there are different
download cables for the two D
The adjacent illustrations shows P/N's as well as
connection of the download cables.
On D V with S/N 01000 or lower, the rear cover
UO IEW
must be removed to access the connectors.
A complete description of the software installation
can be found in the "Surgical Display Controller –
Software Installation Instructions" delivered with the
SDC-SW.
Note: The D V
UO
KION-i workstation. Thus, the KION / KION-i must be
switched to Standby or On during the software
installation.
Siemens-Elema AB
V .
UO IEW
V
UO
with S/N 01000 or lower.
with S/N 01001 or higher.
V versions.
UO IEW
is power supplied by the KION /
IEW
E382 E392E 061 01 02 02
KION / KION-i
:
IEW