APPENDIX C: NETWORK CONNECTIVITY
Your IP Device is designed to be controlled using your existing local network and the provided
DigiConsole and DigiViewer software. You can also view your device remotely using Yoics Remote
Access.
1. Connect the device to the router or switch using an Ethernet cable, and power on the device.
NOTE: The device must be connected to the router prior to connecting power to the IP device.
2. Locate the MAC and IP address of your device using DigiConsole. For details, see "Locating
the IP and MAC addresses" on page 81.
3. Run DigiConsole from the provided software CD (optional installation to PC), and configure
DigiViewer to allow DDNS connectivity. For details, see "Appendix E: Setting Up DDNS
Service" on page 83.
DDNS
LNZ4001
Figure 30.0 Network connectivity diagram
80
REMOTE COMPUTER
INTERNET
LNE3003
MODEM
ROUTER
DDNS
iPHONE / iPOD TOUCH
LOCAL COMPUTER