Lighting; Device Setup; Local Network Settings - Lorex LNE1001 Instruction Manual

Settings

Lighting

To configure lighting settings:
1. Under Illuminator control, select AUTO, ON, or OFF from the drop-down menu. This option
control the night vision LEDs around the lens. By default, the camera is set to Auto.
2. Under Mode, select Outdoor, Indoor 50 Hz, or Indoor 60 Hz. This option controls the mode of
the night vision LEDs. By default, the camera is set to Indoor 60 Hz.
NOTE: With the IR Sensor set to auto, you can still set the mode to Outdoor, Indoor 50 Hz, or Indoor 60 Hz.
3. Click Submit Preferences. Please allow a few moments for your camera to update.

Device Setup

The Device Setup menu controls the Internal Networking Information for the IP Device.
To open the Device Setup menu:
>
• Click Settings Device Setup
Figure 20.0 Device setup menu

Local Network Settings

To configure local network settings:
1. Under Device Hostname, enter a name for your device. This will be the name of your device
on your local network.
2. Under Video Streaming, select the video quality for your network configuration:
• Local Area Network
(MPEG4-640x480)
• Internet/LAN (MPEG 4-640x480)
[default]
• High Speed (MPEG
4-640x480-CBR)
3. Click Submit Network. Please allow a few moments for your camera to update.
58
• Slow Internet (MPEG
4-320x240)Internet/LAN
(MJPEG-640x480)
• High Speed (MJPEG - 320x240)
• Slow Internet (MJPEG - 160x120)