Using Yoics
Setting Up Wireless Connectivity
ATTENTION: This section is applicable to wireless camera models
With initial setup of the camera complete, you can configure settings in DigiViewer to employ a
wireless network connection.
To setup wireless connectivity:
1. From DigiViewer, click Settings and then click Wireless. DigiViewer automatically scans for
any wireless networks.
2. If not already enabled, select Enabled from the Wireless Mode drop-down menu.
Figure 8.7 Enable a wireless connection
3. From the list of available networks, select the wireless network for the device. If protection/
encryption is enabled on the wireless router, you must enter the network password.
Figure 8.8 Select your wireless connection (enter password if
necessary)
4. Click Connect. Allow DigiViewer a few moments to apply your new connection settings.
NOTE: Changing wireless settings may require devices to reconnect.
Figure 8.9 Your device may need to reconnect with the new wireless settings
5. Close the browser window.
6. Return to DigiConsole. From the Find menu, right-click your camera and select Refresh the
list of devices (If DigiConsole was closed earlier, run the software again and click Find).
NOTE: The camera should appear twice, with a different IP address (wired and wireless).
7. Disconnect the network cable from the camera.
8. Double-click the camera to launch DigiViewer in your default browser.
NOTE: If using a Mac, use Bonjour in Safari to auto-detect your camera.
28
only
.