Appendix J: Registering, Removing, and Resetting Yoics Services
Removing Services Using DigiViewer
You can also remove all Yoics services registered to your camera using DigiViewer.
To remove Yoics servics using DigiViewer:
1. Open DigiViewer in your default browser using DigiConsole or through the camera's IP
address/DDNS domain name.
2. Log in to your camera using your user name and password (by default, admin/admin).
3. Click Settings and then click Remote Access.
4. Under Yoics Instant Networking, click Unregister.
Figure 39.7 Click Unregister to remove all Yoics services
NOTE: Press F5 on your keyboard to refresh the page.
NOTE: Performing a hard reset of your camera will also remove all Yoics services registered to your
camera. For details, see "Appendix I: Rebooting, Resetting, and Recalibrating the Camera" on page 92.
Resetting Yoics Services
If you remove Yoics services using DigiViewer or due to a hardware reset, you can quickly reset
the services from the Yoics website.
To reset Yoics services:
1. In your browser, go to www.yoics.com and log in using your Yoics ID and password.
2. A pop-up will alert you to the fact that Yoics remote viewing services have been removed from
your camera. Click Reset Service.
Figure 39.9 Rest Yoics service
3. Repeat step 2 for remaining Yoics services.
98