Alarm Output - Lorex LNE1001 Instruction Manual

Alarm Output

To configure alarm output settings:
1. Connect an external alarm, such as light or
siren, to the two right ports of the alarm block
on the rear panel of the camera.
2. Open DigiViewer and click Events
Input/Output.
3. Under Alarm Output, select the box, Alarm
output.
4. Under Digital Output, select High for a
Normally Open circuit (NO) or Low, for a
Normally Closed circuit (NC).
NOTE: Trigger Condition will always be Alarm.
5. Under alarm, select the following:
• Motion detection: the external alarm (light, siren) will be triggered when motion is detected
by the camera
• Alarm input: the external alarm (light, siren) will be triggered when the connected alarm
sensor is triggered
• Select both if desired
6. Under Alarm duration, select 1~60 seconds, or OFF. The longer the duration, the longer the
light/siren will be active.
NOTE: Effective period is set to always by default.
Figure 18.10 Alarm output
7. Click Submit In/Output to save your settings.
>
Alarm
Figure 18.9 Alarm output
Ground
Alarm
Events
SIREN
55