Appendix F: Connecting Alarm And Motion Devices - Lorex LNE1001 Instruction Manual
Remote surveillance internet camera wired, wireless, pan/tilt, easy connect
Hide thumbs
Also See for LNE1001:
- Specifications (2 pages) ,
- Quick setup manual (2 pages) ,
- Instruction manual (143 pages)
Table of Contents
Advertisement
APPENDIX F: CONNECTING ALARM AND
MOTION DEVICES
This section is applicable to LNZ4001 Series models
PTZ INTERNET CAMERA
SENSOR
Figure 35.0 Alarm block on rear panel of LNZ4001 cameras
You can connect 12V alarm and motion devices to an LNZ4001 Series camera. When an alarm is
triggered, the PTZ Internet camera can be set to automatically turn towards the triggered area.
To connect an external alarm sensor to the system:
1. Connect the Signal Cable to the desired left-most port
on the rear panel.
2. Connect the Ground Cable to the port (second from
left) on the rear panel.
3. If desired, connect an alarm or siren to the output
ports on the rear panel.
4. Enable Alarm Input and Output in
>
DigiViewer
Events
complete details, see "Alarm Input/Output" on
page 54.
86
GROUND CABLE
>
Alarm Input/Output. For
only
.
INPUT
SIGNAL CABLE
Figure 35.1 Alarm block connections
GROUND
OUTPUT
ALARM
CABLE
ALARM / SIREN
Advertisement
Table of Contents
