System
Use the System menu to access Advanced Parameter Settings to perform device maintenance
and firmware upgrades.
Figure 26.0 Advanced Parameters menu—Maintenance and upgrades
Advanced Parameter Settings
The restart your camera:
• Restart Camera: Click Reboot to restart your camera. Wait a few moments for device to restart
To restore factory defaults:
• Factory Settings: Click Restore to restore your device to its factory settings. Wait a few
moments for the changes to take effect
Upgrading Firmware
When new firmware becomes available for your product,
you can use DigiViewer to upgrade the device.
NOTE: Ensure your device is connected to your network prior
to performing a firmware upgrade.
To upgrade firmware:
1. Visit
www.lorexcctv.com
firmware for your camera from its product page.
2. Open DigiViewer.
3. Click Settings and then click System.
4. From the System menu click Browse to locate the
firmware file on your PC and then click Update.
5. Click OK in the dialogue box to confirm the file transfer.
NOTE: Allow a few moments for the upgrade to take place. Status bars will show the progress of the
see figure 26.2
upgrade (
Figure 26.2 Upgrade progress.
and download the latest
). DigiViewer will reset to the main screen once the upgrade is complete.
Figure 26.1 Select the file and click Open.
Settings
69