Resetting The Camera; Recalibrating The Camera - Lorex LNE1001 Instruction Manual

Resetting the Camera

If you are still experiencing problems with your camera, you can perform a hardware reset.
To reset your camera:
1. Make sure the camera is powered on and connected to
your network.
2. Using a pin, press and hold the Reset button on the
rear panel of the camera for 10~15 seconds.
3. Release the button. After a few moments you should
hear a couple of "clicks" from the lens and the image
in DigiViewer will go black. The lens of the PTZ camera
will spin and recalibrate.
4. Wait for DigiViewer to return to Surveillance mode and
then click to resume live viewing.
NOTE: If you are using a PTZ Internet Camera, you may need
to recalibrate the camera after performing a hardware reset.
NOTE: Performing a hard reset will remove all Yoics remote viewing services registered to your camera.
You will need to register for Yoics services (Video Stream, Camera Viewer) again at www.yoics.com. For
complete details on registering and removign Yoics services, see "Appendix J: Registering, Removing,
and Resetting Yoics Services" on page 94.

Recalibrating the Camera

NOTE: This section is applicable to LNZ4001 camera model only.
Your PTZ Internet camera may need to be recalibrated if you ever reposition the camera or
perform a hardware reset.
To recalibrate the camera:
1. From DigiViewer, click Events and then click Preset.
2. Click Calibration. The lens will spin and re-orient itself to the position of the camera.
Figure 38.2 Click Calibration
3. Click Surveillance and then click
4. Click to open PTZ controls.
5. Use the PTZ navigation arrows to verify that the camera has been calibrated properly. If not,
repeat steps 1~2.
Appendix I: Rebooting, Resetting, and Recalibrating the Camera
to resume live viewing.
Figure 38.1 Hold Reset for 10~15 sec.
93