Connecting To A Wireless Network - Konica Minolta bizhub C3100i User Manual

Connecting to a Wireless Network

Preparing to Use a Wireless Network
Perform the following procedures before configuring the wireless settings.
1.
Press the <Menu> button.
2.
Press the or
3.
Press the or
4.
If [Ethernet] is selected, press the
If [Wi-Fi] is selected, proceed to wireless network connections.
5.
If a confirmation screen appears, turn off the machine, and then turn it on again.
Wi-Fi settings can be configured as follows.
"Automatically Connecting to a Wireless Network" (P.16)

"Manually Connecting to a Wireless Network" (P.17)

"Connecting Using [Quick Setup] (Windows)" (P.18)

"Connecting Using Support Tools (Windows)" (P.19)

Automatically Connecting to a Wireless Network
This machine supports wireless LAN connection using WPS (push button method) and WPS (PIN
code method).
 For WPS (push button method), configure the settings on the operator panel, and then press the
WPS button on your access point or wireless router.
 For WPS (PIN code method), enter the PIN code assigned to the machine into the access point or
wireless router.
These methods are available only when the access point or wireless router supports WPS.
 For details about the WPS operation on the access point or wireless router, see the manual supplied with
the access point or wireless router.
When Connecting With WPS (push button method)
1.
When [Press WPS Button on router] appears on the display, press the <WPS> button.
2.
Press the WPS button at the wireless network access point within two minutes.
When connection to an access point or wireless router is complete, the machine will restart
automatically.
You can perform the same settings configuration from the settings menu. For details, refer to "[WPS

Setup]" (P.58).
16
2 Setting Up the Machine
button, select [Network Settings], and press the
button, select [Network], and press the
or
button.
button, select [Wi-Fi], then press the
button.
button.