Preparation; Connecting To A Computer - Konica Minolta CM-36dGV Instruction Manual

Preparation

 Connecting to a Computer
Connect the instrument to the computer with the supplied USB cable IF-A17 (2 m).
Notes
Be sure to connect the USB cable to the designated USB terminal on the instrument when it is used.
Memo
• Instrument USB communications conform to USB 2.0.
• When connecting the instrument to the computer, the dedicated USB driver must be installed. Install the USB
driver supplied with the software that enables connection and operation of the instrument.
• The instrument cannot be powered through the USB cable. Connect the AC adapter before use.
• Make sure that the USB connector plug is oriented correctly and connected securely.
• When connecting/disconnecting the USB cable, be sure to hold the connector plug. Do not pull on or forcibly
bend the cable. Otherwise, wire breakage may result.
• Make sure that the cable has sufficient length. Putting tension on the cable may cause connection failure or wire
breakage.
• Firmly push in the USB cable connector that matches the shape of the port (connection terminal) until it can go
in no further.
Setting Procedure
In general, a USB cable can be connected/disconnected while the instrument is turned ON. However, in the
following procedure, the instrument is turned OFF before connecting. For information about connecting the AC
adapter and power ON/OFF, refer to P.19.
1 Turn the instrument power OFF.
2 Connect the USB cable Type-B connector to the USB
terminal on the instrument.
• Fully insert the connector and ensure the connection is secure.
3 Connect the USB cable Type-A connector to the USB port
on the computer.
4 Connect the AC adapter and turn the instrument power
ON.
• When installation of the USB driver is prompted, specify
the USB driver included with the software to complete the
installation.
• After installation of the USB driver is completed, turn the
power OFF and then back ON again.
18