Set The Date And Time - YASKAWA GA800 Technical Reference

3.
Push or
4.
Push or
5.
Push or
The procedure to set the keypad language is complete.
◆

Set the Date and Time

The procedure in this section shows how to set the date and time.
Note:
• Refer to
Replace the Keypad Battery on page 475
To set the drive to detect an alarm when the battery is dead or when the clock is not set, install the battery then set o4-24 = 1 [bAT Detection
selection = Enable (Alarm Detected)].
• If the keypad does not have a clock battery, you must set the date and time each time you energize the drive.
1.
Push (Home) to show the HOME screen.
Note:
• When the drive is in HOME Mode, the screen shows [Home] in the upper right-hand corner of the screen.
• If [Home] is not shown on
2.
Push (Menu).
YASKAWA SIEPC71061737D GA800 Drive Technical Reference
to select [Initial Settings], then push
to select [Language Selection], then push
to select the language, then push
for information about the battery installation procedure.
, push (Back) to show [Home] on
.
.
.
.
4.6 Keypad Operation
201
4