Installation Position And Clearances; Install Single Drive; Install Drives Side-By-Side - YASKAWA GA800 Technical Reference

2.3

Installation Position and Clearances

Install the drive vertically for sufficient airflow to cool the drive.
Note:
Contact Yaskawa or a Yaskawa representative for more information about installing drive models on their side.
A - Vertical installation
◆

Install Single Drive

Use the clearances specified in
airflow to cool the drive.
A - 50 mm (2 in) minimum
B - 30 mm (1.2 in) minimum on each side
◆

Install Drives Side-by-Side

You can install drive models 2004xB to 2082xB and 4002xB to 4044xB side-by-side.
When you install other drives side-by-side, make sure that you keep the necessary clearances between the drives for
single drive installation.
The installation clearances shown in
Method Selection = Side-by-Side Mounting].
Derate the output current to align with the ambient temperature. Refer to
Temperature on page 505
YASKAWA SIEPC71061737D GA800 Drive Technical Reference
Figure 2.1 Installation Orientation
Figure 2.2 to install the drive. Make sure that there is sufficient space for wiring and
Figure 2.2 Installation Clearances for One Drive
Figure 2.3 are necessary for side-by-side installation. Set L8-35 = 1 [Installation
for more information.
2.3 Installation Position and Clearances
B - Horizontal installation
C - 120 mm (4.7 in) minimum above and below
D - Airflow direction
Derating Depending on Ambient
2
37