The screen will show the monitors as shown in this figure.
◆
Set the Monitors to Show as Analog Gauges
The procedure in this section shows how to show the frequency reference monitor as an analog gauge.
1.
Push
[Home] to show the HOME screen.
Note:
• The keypad will [Home] in the top right corner when the HOME screen is active.
• If [Home] is not shown on
2.
Push
[Menu].
3.
Push
or
4.
Push
or
5.
Push
.
6.
Push
or
Monitor Set the x-xx part of the Ux-xx. For example, to show monitor U1-01 [Frequency Reference], set it to
"101" as shown in this figure.
YASKAWA SIEPC71061737D GA800 Drive Technical Reference
, push
[Back] to show [Home] on
to select [Monitors], then push
to select [Analog Gauge], then push
to select the monitor number to register, then push
.
.
[Setup].
.
4.6 Keypad Operation
181
4