Keypad Operation; Home Screen Display Selection - YASKAWA GA800 Technical Reference

4.6

Keypad Operation

Note:
Make sure that you use a keypad that has a flash number of 1004 or later. Keypads that have a flash number of 1003 or earlier will not show
characters correctly.
◆

Home Screen Display Selection

This section gives information about the content shown on the HOME screen and the functions that you can control
from the HOME screen.
■
View Monitors Shown in Home Screen
This figure shows monitor data in the data display area of the HOME screen.
• To change what the screen shows, change the setting for o1-40 [Home display selection].
• When o1-40 = 0 [Home Screen Display Selection = Custom Monitor], and there is more than one screen, use
or to switch between screens.
■
JOG Operation
Push to illuminate
motor.
■
Change Motor between Forward/Reverse Run
You can change the direction of motor rotation when operating the drive from the keypad. Push
.
Push and hold [FWD/REV] to toggle the direction of motor rotation between forward and reverse.
■
Show the Standard Monitor
Push to show the standard monitor (Ux-xx). When you push
screen.
Note:
When a fault, minor fault, or an error occurs, push
xx).
YASKAWA SIEPC71061737D GA800 Drive Technical Reference
. Push and hold [JOG] to run the motor. Release
to show the content of the fault. Push

4.6 Keypad Operation

[JOG] to stop the
[HOME], the keypad goes back to the home
again to show the standard monitor (Ux-
4
to illuminate
175