Show Custom Monitors - YASKAWA GA800 Technical Reference

4.6 Keypad Operation
5.
Push or
6.
Push or
Set the x-xx part of monitor Ux-xx. For example, to show monitor U1-05, set it to "105" as shown in this figure.
The configuration procedure is complete.
◆

Show Custom Monitors

The procedure in this section shows how to show the registered custom monitors.
1.
Push [Home] to show the HOME screen.
Note:
• The keypad will [Home] in the top right corner when the HOME screen is active.
• If [Home] is not shown on
2.
Push [Menu].
3.
Push or
4.
Push or
The keypad shows the selected monitor as shown in this figure.
178
to select [Custom Monitor 1], then push
to select the monitor number to register, then push
, push [Back] to show [Home] on
to select [Monitors], then push
to select [Custom Monitor], then push
.
.
.
.
.
YASKAWA SIEPC71061737D GA800 Drive Technical Reference