Set The Monitors To Show As A Bar Graph - YASKAWA GA800 Technical Reference

• When there are a minimum of two screens, push
• If you registered only one custom monitor to [Custom Monitor 1], the screen will show only one monitor. If you
registered custom monitors only to [Custom Monitor 1] and [Custom Monitor 2], the screen will show only two
monitors.
◆

Set the Monitors to Show as a Bar Graph

The procedure in this section shows how to show the frequency reference monitor as a bar graph.
1.
Push [Home] to show the HOME screen.
Note:
• The keypad will [Home] in the top right corner when the HOME screen is active.
• If [Home] is not shown on
2.
Push [Menu].
3.
Push or
4.
Push or
5.
Push or
YASKAWA SIEPC71061737D GA800 Drive Technical Reference
, push [Back] to show [Home] on
to select [Monitors], then push
to select [Bar Graph], then push
to select the location to store the monitor, then push
or to switch between screens.
.
.
[Setup].
4.6 Keypad Operation
.
4
179