Set The Monitors To Show As Analog Gauges - YASKAWA GA800 Series Technical Reference

The screen will show the monitors as shown in this figure.
◆

Set the Monitors to Show as Analog Gauges

The procedure in this section shows how to show the frequency reference monitor as an analog gauge.
1.
Push (Home) to show the HOME screen.
Note:
• The keypad will show [Home] in the top right corner when the HOME screen is active.
• If [Home] is not shown on
2.
Push (Menu).
3.
Push or
4.
Push or
5.
Push .
6.
Push or
Enter the three digits in "x-xx" part of monitor Ux-xx to identify which monitor to output. For example, to show
monitor U1-01 [Frequency Reference], set it to "101" as shown in this figure.
YASKAWA SIEPC71061737B GA800 Drive Technical Reference
, push (Back) to show [Home] on
to select [Monitors], then push
to select [Analog Gauge], then push
to select the monitor number to register, then push
.
.
(Setup).
.
4.6 Keypad Operation
157
4