Fpx 36-Dv - Travis Industries Spirit 300 GS Service Manual

FPX 36-DV

Arch Faces
Use the inside
attachments on the
side and the
attachment at the
center of the face.
To remove the glass:
Remove the arch covers
(1)
Unscrew the glass clip screws several turns to loosen them from the clips.
(2)
Slide off the glass clips on the top and sides of the glass, holding the glass to insure it does not fall forward
(3)
Loosen the glass clip on the bottom
(4)
Slide the glass up and away from the bottom glass clip
(5)
Front of Fireplace
Glass Clip
Glass
Travis Industries
Door & Glass Removal
Glass Gasket (fits
around edge of glass)
These key-holes allow for glass
clip removal without removing
the screws.
Bracket for securing
the faceplate
Gas T-Shoot Guide
Rectangular Faces
There is no center
attachment for
rectangular faces.
Older faces use a #3
square driver (included
Phillips in the fireplace ownerÕs
Screwdriver pack).
To install the glass:
Place the bottom glass clip in place and screw the 5
(1)
screws that hold it in place a couple of turns (use a
phillips screwdriver)
With the glass gasket in place, position the glass on
(2)
the bottom glass clip (if the glass is cracked or broken,
replace)
Install the side and top glass clips, tightening the
(3)
screws only a couple of turns
(4) Adjust the glass so it is centered
(5) TIghten the screws on the glass
clips all the way (screws must bottom out)
Glass
Clip
Phillips
Screwdriver
Glass
Gasket
Glass Clip
Screws
3 - 5
Glass
Face of
Firebox
19203