Travis Industries Spirit 300 GS Service Manual page 34

Burner Pan Components
4 - 2
Burner Assembly Removal - BVM, DVS & DVM Burners
Warning Shut off all gas to the appliance prior to conducting service.
Access the firebox (see Door & Glass Removal if necessary).
NOTE: When installed, the log
shelf must maintain a parallel
3/8Ó gap to the burner pan.
1 Remove the log
shelf following the
directions above.
2 Remove the gas
inlet following the
directions to the
right.
3 Remove the
burner pan
following the
directions to the
right.
Travis Industries
The rear log shelf slides on and off the
burner pan assembly
Stoves
The gas inlet on freestanding
stoves protrudes from the
rear panel.
Disconnect the gas supply from the
gas inlet and turn the pipe counter-
clockwise with a pipe wrench.
Disconnect the six nuts
c
used to attach the
burner pan.
Disconnect the brown and red
b
wires from the on/off switch.
Gas T-Shoot Guide
Rear
Rear
Log
Log
Shelf
Shelf
Make sure the two tabs
slide over the side of the
burner pan on both sides.
Burner Pan
Assembly
Inserts
The gas inlet on inserts is on
the left side - either facing to
the rear or to the left.
3/8" M.P.T to 1/2" O.D. Fitting
Flex
Tube
Remove the burner pan, tilting it forward to
d
allow the gas control valve to clear the
front of the heater.
Position the
shelf so the
back edges
of the shelf
and burner
pan are flush.
DVS Fireplaces
Disconnect the flex tube
from the fitting on the gas
control valve.
PILOT ADJ
Gas Control
Valve
Hold the fitting in place while
unscrewing the flex tube.
7/16Ó Socket
Wrench
(use an
extension)
Disconnect the
a
orange wire from the
burner pan to the
piezo igniter.
19203