Burner Asembly Removal - Dvl Burners - Travis Industries Spirit 300 GS Service Manual

Burner Pan Components
Burner Assembly Removal - DVL Burners
Warning Shut off all gas to the appliance prior to conducting service.
Heritage Bay Only
Remove the control panel following the directions below.
Access the firebox and remove the burner pan following the directions below
e
Remove the burner pan, tilting
it forward to allow the gas
control valve to clear the front
of the heater.
d
Disconnect the six nuts
used to attach the
burner pan.
7/16Ó
Socket
a
Disconnect the orange wire from the burner
pan to the piezo igniter.
Travis Industries
Open the Door
on the pedestal.
Gas T-Shoot Guide
Remove the four screws holding
the control panel in place.
1/4" Nutdriver
Lay the control panel face
down so the area behind it may
be accessed.
Burner Pan
Control Panel
b
Disconnect the brown and red
wires from the on/off switch.
c
Hold the fitting in place with the 3/4"
wrench while unscrewing the flex tube.
4 - 3
19203