Lopi Spirit (Bv & Dv) Blower Removal - Travis Industries Spirit 300 GS Service Manual

Lopi Spirit (B-Vent & DV) Blower Removal
Warning Make sure the power cord is disconnected prior to conducting service.
Warning Shut off gas to the heater - you may need to disconnect the gas line
depending upon the heater location and the type of gas connection.
1 Remove the two screws on the cover plate
around the gas inlet. Unscrew the nine
screws holding the rear panel in place.
Cover Plate
3 Remove the nuts holding the left side
panel to the baseplate.
Remove these nuts (left side only)
5 Remove the left side panel by lifting up on
the top convection panel and lifting the
panel free of the base.
6 With the left rear of the heater exposed,
the blower assembly can be accessed.
Follow the directions on page 5-5 (A20
Blower Assembly Removal & Disassembly)
to remove the blower from the heater.
Travis Industries
Blower Components
Gas T-Shoot Guide
2 Swing the rear panel to the left and
disconnect the molex connector leading
from the power cord.
4 Remove the nuts holding the left side
panel to the convection top.
Remove these nuts (left side only)
5 - 3
Remove the Molex Connection
19203