Travis Industries Spirit 300 GS Service Manual page 52

5 - 8
7 Disconnect the electrical connections to the blower (orientation does not matter when re-
connecting). Remove the two nuts on the left side of the blower.
8 Remove the blower from the heater.
9 When re-installing, make sure to position the brackets correctly behind the blower assembly.
Travis Industries
Blower Components
Disconnect the two wires
leading to the blower.
Gas T-Shoot Guide
Remove the two nuts
(and washers) holding
the blower in place.
Mounting Plate
on Heater
Nut
Washer
Blower
Plate
Rubber
Grommet
& Bushing
Stud
Plate
19203