Blower Rheostat Removal - Travis Industries Spirit 300 GS Service Manual

Blower Rheostat Removal

Warning Make sure the power cord is disconnected prior to conducting service.
Warning Shut off gas to the heater - you may need to disconnect the gas line
depending upon the heater location and the type of gas connection.
Remove the rheostat following the directions below.
Pull the
knob off.
Blower Snap Disk Removal - Heritage Bay Stove & FPX 36-DV
Warning Make sure the power cord is disconnected prior to conducting service.
Warning Shut off gas to the heater - you may need to disconnect the gas line
depending upon the heater location and the type of gas connection.
Heritage Bay Only
Remove the control panel
following the directions to the
right.
T
he blower snap disk is located underneath the burner pan on the right side. Disconnect the black &
white wires from the snap disk (orientation does not matter when re-connecting).
Travis Industries
Blower Components
Disconnect
the wires.
Unscrew
this nut.
Open the Door
on the pedestal.
Gas T-Shoot Guide
NOTE: this tab fits into the hole on
the mounting bracket.
Remove the four screws holding
the control panel in place.
1/4" Nutdriver
Lay the control panel face
down so the area behind it may
be accessed.
Remove the snap disk from its
bracket below the firebox.
Phillips
Screwdriver
Blower Snap Disk
610046
T-O-D 60T12
9305
F120-10F
5 - 11
Control Panel
19203