2 - 14
Remote Thermostat Faulty
The remote thermostat consists of two components, the transmitter and receiver. Follow the
instructions below to check the remote thermostat.
Note:
The remote thermostat, when in thermostat mode, may require up to 5-1/2 minutes to
react to changes made to the heat setting. The remote works on 5-1/2 minute cycles for
updating the temperature.
Note:
The remote thermostat has a 20Õ range to the receiver and must be within direct line of
sight. Weak batteries may adversely affect range.
1
Switch the receiver to ÒMANUALÓ and turn the heater on.
the malfunction is with the heater (or in rare cases with the remote receiver or the wire
leading to it)
2
Switch the receiver to ÒREMOTEÓ. Install new batteries in both the receiver and remote
and press the ÒMANÓ button on the remote. Then press ÒONÓ. If the heater does not turn
on, the remote is not operational
Slide the cover off of the
back of the remote
control to access the
battery holder.
Travis Industries
Troubleshooting Steps
Remote Position
Install a 9 volt battery in
both the remote control and
remote control receiver.
Gas T-Shoot Guide
Manual Position
Off Position
This clip holds the
battery in place.
If the heater does not work,
Remote
Control
Receiver
(with cover
plate
removed)
19203