Door & Glass Removal; Lopi Spirit, Spirit Dv, & Spirit Bay - Travis Industries Spirit 300 GS Service Manual

Lopi Spirit, Spirit DV, & Spirit Bay
Remove the door by lifting up on it and swinging it to the left. Then lift it up and off of the hinges.
Remove the glass by following the directions below.
To replace the glass:
Follow the directions above in reverse order. Make sure the
gasket forms an air-tight seal around the perimeter of the glass.
Cross Section of
Glass Attachment
NOTE: Some models do not have key-hole slots in the glass clips. Simply remove the nuts to
remove the glass clips.
Travis Industries
Door & Glass Removal
To remove the glass:
a
Loosen the nuts on the top and
right side glass clips. Then
slide the glass clips off.
b
Loosen the nuts on the bottom and
left side glass clip. Then slide the
glass to the right, pivot the glass
forward, and remove it from the
heater.
Gas T-Shoot Guide
Glass Clip
Attachment Studs
Face of Heater
Glass Gasket
(5/8" self-adhesive
channel gasket)
Glass Clip Nuts
Glass Clip
Glass
3 - 1
19203