Travis Industries Spirit 300 GS Service Manual page 40

Burner Pan Components
4 - 8
Pilot Assembly Removal, Disassembly - 1997
Warning: The pilot tube is a common location of gas leaks - check this area after
conducting any service on the pilot tube.
Remove the burner pan (not the entire burner assembly) following the directions above.
The pilot assembly may be removed in its entirety by disconnecting the thermocouple, thermopile,
pilot tube, and piezo igniter wire. Or, if you wish, you can remove an individual component separately.
To remove the pilot assembly,
remove the two screws holding the
assembly in place. Then pull up on
the pilot hood until the assembly
can be accessed from the bottom.
Spark Electrode
(part of the pilot assembly)
Thermopile
(remove from the bottom)
Piezo Igniter Wire
(to disconnect, remove the
orange wire leading to the piezo
igniter)
Pilot Tube Nut
Pilot orifice is inside
(remove from the bottom)
Travis Industries
7/16" Wrench
Do not kink or excessively bend the
pilot tube - this may lead to leaks.
Gas T-Shoot Guide
Pilot Assembly
IMPORTANT NOTE:
Make sure the pilot asembly does not rotate
while detaching components from the pilot
assembly. Insert a standard screwdriver
between the components or use a vice-grip to
clamp the assembly in place.
Pilot Hood
(flexible pilot tube)
Thermocouple
(remove from
the bottom)
Disconnect
Connect
19203