Spark Electrode Removal; Piezo Igniter Removal; On/Off Switch - Travis Industries Spirit 300 GS Service Manual

Burner Pan Components

Spark Electrode Removal

The spark electrode is incorporated into the pilot assembly - replace the entire assembly (for 1997 or
later models see page 4-8, 1996 or earlier see page 4-7).
Piezo Igniter
To remove the piezo igniter, follow the directions below.
Unscrew the nut - usually
this can be done by hand,
otherwise use an 1-1/16"
open end wrench.
Slide the piezo
igniter forward

On/Off Switch

Remove the on/off switch following the directions below.
Warning When replacing the switch, make sure to secure the wires so they do not contact the
bottom of the burner pan and melt.
Travis Industries
Remove the orange piezo wire
from the pizo igniter.
b
Carefully thread the on/off
switch out, making sure not
to disconnect or damage
the wiring.
Gas T-Shoot Guide
a
Depress the locking tabs on the back of
the on/off switch. Use a screwdriver, if
necessary, to gain enough leverage.
Note the orientation
of the wiring on back
of the switch before
detaching the wires.
c
4 - 11
19203