Travis Industries Spirit 300 GS Service Manual page 49

A20 Blower Assembly Removal & Dissassembly
1 Disconnect the wires leading
to the blower. Remove the
four nuts holding the blower
assembly in place.
2 Remove the four nuts
holding the blower in place.
Slide the blower out.
3 When re-installing, make sure
to position the brackets
correctly behind the blower
assembly.
Travis Industries
Blower Components
Gas T-Shoot Guide
Disconnect the two wires
leading to the blower.
NOTE: orientation does
not matter while
reinstalling.
Remove the four nuts
holding the blower in place.
11/32" Nutdriver
Slide the blower out to the side.
Mounting Plate
on Heater
Nut
Washer
Blower
Plate
5 - 5
Rubber
Grommet
& Bushing
Stud
Plate
19203