Travis Industries Spirit 300 GS Service Manual page 39

Burner Pan Components
Pilot Assembly Removal, Disassembly - 1996
Warning: The pilot tube is a common location of gas leaks - check this area after
conducting any service on the pilot tube.
Remove the burner assembly following the directions on page 4-2 (DVM) or 4-3 (DVL).
Place the burner assembly upside down on a work surface.
Disconnect and move the pilot tube away from the pilot assembly following the directions below.
Pilot
Assembly
Gas
Control
Valve
The pilot assembly may be removed in its entirety by disconnecting the thermocouple, thermopile,
and pilot tube. Or, if you wish, you can remove an individual component separately.
Thermocouple Port
(thermocouple is inside)
Pilot Assembly Screws
1/4" Nutdriver
Travis Industries
Pilot Tube
Pilot Assembly Gasket
Gas T-Shoot Guide
(inflexible pilot tube)
Unscrew this
a
compression nut.
Swivel the pilot tube
c
up to access the
pilot orifice.
Loosen (do not remove)
b
this connection.
Piezo Igniter Wire
(leads to spark
electrode)
Pilot Tube Compression Nut
(sleeve & pilot orifice are inside)
Pilot Assembly
Thermopile Port
(thermopile is inside)
4 - 7
19203