Icom IC-7000 Instruction Manual page 142

13
SET MODE
■ Miscellaneous (others) set mode
30 H H M M - - 1 1 5 5 1 1 [ [ F F - - 1 1 ] ]
This item programs one of several functions to [F-1]
key of HM-151. Programmable key assignments are
described as below.
"P.AMP/ATT" (Preamplifier/attenuator),
"NB" (Noise blanker),
"NR" (Noise reduction),
"MNF" (Manual notch filter),
"ANF" (Auto notch filter),
"TS" (Tuning step),
"SPL" (Split operation),
"A/B" (VCO A/B selection),
"MCL" (Memory clear),
"BNK" (Bank selection),
"COM" (Speech compressor),
31 H H M M - - 1 1 5 5 1 1 [ [ F F - - 2 2 ] ]
This item programs one of several functions to [F-2]
key of HM-151. Programmable key assignments are
same as above.
32 M M I I C C U U p p / / D D o o w w n n S S p p e e e e d d
This item sets the rate at which frequencies are
scanned when the microphone (HM-151) [Y Y ]/[Z Z ]
keys are pushed and held. High or low can be se-
lected.
33 Q Q u u i i c c k k R R I I T T / / ∂ ∂ T T X X C C l l e e a a r r
This item selects the RIT/∂TX frequency clearing in-
struction for the [F-3 C C L L R R ] key.
See pgs. 73, 86 for details.
34 S S S S B B / / C C W W S S y y n n c c h h r r o o n n o o u u s s T T u u n n i i n n g g
This item selects the displayed frequency shift func-
tion from ON and OFF.
When this function is activated, the received signal
will remain the same even when the operating mode
is changed between SSB and CW.
The frequency shifting value may differ according
to the CW pitch setting.
133
(continued)
M M P P W W
Memo pad write is pro-
grammed. (default)
"AGC" (AGC selection),
"TBW" (TX filter width),
"DUP" (Duplexer),
"TON" (FM tone operation),
"MET" (Meter selection),
"VSC" (Voice squelch control),
"MPW" (Memo pad write),
"MPR" (Memo pad read),
"<SCOPE>" (Scope selection),
"<METER>" (Multi-meter selection)
M M P P R R
Memo pad read is pro-
grammed. (default)
H H I I G G H H
High speed (default,
5 tuning steps/sec.)
O O N N
Clears the RIT/∂TX fre-
quency when [F-3 C C L L R R ] is
pushed momentarily.
O O N N
The displayed frequency
shifts when the operating
mode is changed between
SSB and CW.
A A N N F F
Auto notch filter is pro-
grammed.
N N B B
Noise blanker function is
programmed.
L L O O W W
Low speed
(2.5 tuning steps/sec.)
O O F F F F
Clears the RIT/∂TX fre-
quency when [F-3 C C L L R R ] is
pushed and held for 1 sec.
(default)
O O F F F F
The displayed frequency
does not shift.
(default)