D Manual Notch Function; D Manual Notch Filter Set Mode - Icom IC-7000 Instruction Manual

5
FUNCTIONS FOR RECEIVE
D D Manual notch function
The manual notch function can be used in SSB, CW,
RTTY and AM modes.
➥ Push [MNF/ADJ] momentarily to turn the manual
notch function ON and OFF.
• " " appears when manual notch function is in use.
• Set the frequency for manual notch filtering via the
manual notch filter set mode. (shown below)
• Even when both of the manual notch filters, "N N F F 1 1 " and
"N N F F 2 2 ," are set to OFF in the manual notch filter set
mode, "N N F F 1 1 " is automatically turned ON if the manual
notch function is ON.
D Manual notch filter set mode
q Push [MNF/ADJ] for 1 sec. to enter the manual
notch filter set mode.
w Push [F-2 N N F F 1 1 ] or [F-3 N N F F 2 2 ] to select the desired
filter ON and OFF.
e Rotate [DIAL] to adjust the selected filter fre-
quency.
• Push [F-4 N N W W ] to toggle the filter width from narrow,
middle and wide.
r Push [MNF/ADJ] (or push [Z Z (
the manual notch filter set mode.
81
)]) to exit
/
MENU GRP
Appears
[MNF/ADJ]
[MNF/ADJ]
[MENU/GRP] [F-2] [F-3] [F-4]
While adjusting the manual notch filter, noise may
be heard. This comes from the DSP unit and does
not indicate an equipment malfunction.
[DIAL]