Icom IC-7000 Instruction Manual page 137

■ Miscellaneous (others) set mode
1 M M o o n n i i t t o o r r
This item sets the TX monitor function ON and OFF.
The monitor gain can be set described below.
2 M M o o n n i i t t o o r r L L e e v v e e l l
This item adjusts the transmit IF signal monitor level
from 0% to 100% in 1% steps.
See p. 87 for details.
3 B B e e e e p p ( ( C C o o n n f f i i r r m m a a t t i i o o n n ) )
A beep sounds each time a switch is pushed to con-
firm it. This function can be turned OFF for silent op-
eration.
The volume level can be set described below.
4 B B e e e e p p ( ( B B a a n n d d E E d d g g e e ) )
A beep sounds when an operating frequency enters
or exits an amateur band. This functions independent
of the confirmation beep setting (above).
The volume level can be set described below.
5 B B e e e e p p L L e e v v e e l l
This item adjusts the volume level for (confirmation
and band edge) beep tones from 0% to 100% in 1%
steps. When beep tones are turned OFF, this setting
has no effect.
6 B B e e e e p p L L e e v v e e l l L L i i m m i i t t
This item allows you to set a maximum volume level
for (confirmation and band edge) beep tones. The
beep tones are linked to the [AF] control until a spec-
ified volume level is reached — further rotation of the
[AF] control will not increase the volume of the beep
tones.
O O N N
TX monitor function is
turned ON.
50% (default)
O O N N
Confirmation beep ON
(default)
O O N N
Band edge beep ON
(default)
50% (default)
O O N N
Beep level is limited with
[AF] (default)
13
SET MODE
O O F F F F
TX monitor function is
turned OFF. (default)
5 0 %
O O F F F F
Confirmation beep OFF
O O F F F F
Band edge beep OFF
5 0 %
O O F F F F
linked
Beep level is to [AF]
13
128