Menu Selection (Example: M) Push [Menu/Grp] Momentarily; Either Y Y Or Z Z; [Pbt/M-Ch/Rit] Indicator; [Menu/Grp] [F-1] - Icom IC-7000 Instruction Manual

Menu group selection
Push [MENU/GRP] for 1 sec.
Selection from: M M , S S or G G (Graphic)
Menu selection (Example: M)
Push [MENU/GRP] momentarily.
Selection from: S S - - 1 1 , S S - - 2 2 or S S - - 3 3

■ Programmed scan operation

q Select S S - - 2 2 .
w Push [F-3 V V / / M M ] to select VFO mode.
e Select the desired operating mode.
• The operating mode can also be changed while scan-
ning.
r Set [RF/SQL] open or closed.
• See page at left for squelch condition.
• If the [RF/SQL] control function is set as "AUTO," the
squelch is always open in SSB, CW and RTTY modes.
See pgs. 1, 35, 129 for details.
t Push [F-1 S S C C N N ] to start the scan.
• Decimal point blinks while scanning.
y When the scan detects a signal, the scan turns
OFF, pauses or ignores it depending on the re-
sume setting and the squelch condition.
u To cancel the scan push [F-1 S S C C N N ].
NOTE: If the same frequencies are programmed
into both scan edge memory channels 1A and 1B,
programmed scan does not start.

■ Memory scan operation

q Select the desired memory bank, if necessary.
● Push [PBT/M-ch/RIT] momentarily to select the
●
M-ch/RIT function, if the twin PBT is selected.
• [PBT/M-ch/RIT] indicator (Green) goes out.
● Rotate [RIT] (outer) control to select the desired ●
memory bank.
w Select S S - - 2 2 .
e Push [F-3 V V / / M M ] to select memory mode.
r Close the squelch with [RF/SQL].
t Push [F-1 S S C C N N ] to start the scan.
• Decimal point blinks while scanning.
y When the scan detects a signal, the scan stops or
pauses depending on the resume setting.
u To cancel the scan push [F-1 S S C C N N ].
NOTE: Two or more memory channels must be
programmed for memory scan to start.
Either Either
Y Y or Z Z
or
[RF/SQL]
[RF/SQL]
[RIT] (outer) control
SCAN OPERATION

[MENU/GRP] [F-1]

[F-3]
then push [F-1 SCN]
[MENU/GRP] [F-1] [F-3]
then push [F-1 SCN]
9
Select
VFO mode
9
Select
memory mode
112