D Programming In Vfo Mode - Icom IC-7000 Instruction Manual

8
MEMORY OPERATION
■ Memory programming
Memory channel programming can be performed ei-
ther in VFO mode or in memory mode.

D Programming in VFO mode

q Push [PBT/M-ch/RIT] momentarily to select the M-
ch/RIT function, if the twin PBT is selected.
• [PBT/M-ch/RIT] indicator (Green) goes out.
w Set the desired frequency and operating mode in
VFO mode.
• If you want to program the split frequency function, pro-
gram both receive and transmit frequencies into VFO
A and B, then turn ON the split function. (p. 89)
• If you want to program a repeater function, set a tone
frequency (p. 60) in addition to the receive/transmit fre-
quencies.
e Select M M - - 2 2 .
r Push [F-1 M M E E M M ] to display the memory channel
contents.
• Memory channel contents appear above the multi-func-
tion key indicator.
• Push [F-1 L L S S T T ] to display the memory channel list.
This is convenient for selecting the desired channel.
Push [Z Z (
/
MENU GRP
t Rotate [M-ch] to select the desired memory chan-
nel.
• " " and "---,---,--" appear if the selected memory
channel is a blank channel (and does not have con-
tents).
• Rotating [RIT] (outer) control changes the bank.
y Push and hold [F-2 M M W W ] for 1 sec. to program the
displayed frequency and operating mode into the
selected memory channel.
To check the programmed contents, push [F-4 V V / / M M ]
to select memory mode.
101
)] to exit the memory channel list.
Menu group selection
Push [MENU/GRP] for 1 sec.
Selection from: M M , S S or G G (Graphic)
Menu selection (Example: M)
Push [MENU/GRP] momentarily.
Selection from: M M - - 1 1 , M M - - 2 2 or M M - - 3 3
[PBT/M-ch/RIT] switch/[M-ch] (inner) control
[PBT/M-ch/RIT] indicator
[MENU/GRP]
[RIT] (outer) control
[EXAMPLE]: Programming 7.088 MHz/LSB into ch 12.
Either Either
Y Y or Z Z
or
[F-2]
MW
Push for
1 sec.