Basic Operation; When First Applying Power (Cpu Resetting); Initial Settings - Icom IC-7000 Instruction Manual

Hf/vhf/uhf all mode transceiver
Hide thumbs Also See for IC-7000:
Table of Contents

Advertisement

3

BASIC OPERATION

■ When first applying power (CPU resetting)
Before first applying power, make sure all connec-
tions required for your system are complete by refer-
ring to Chapter 2. Then, reset the transceiver using
the following procedure.
Resetting CLEARS all programmed contents in
memory channels and returns default values in set
mode.
q Make sure the transceiver power is OFF.
w While pushing and holding [Y Y (
[Z Z (
)], push [PWR] to start resetting.
BAND
• The internal CPU is reset.
• The display changes to 'ALL CLEAR,' 'RF power 100%'
and 'Initial frequency and Mode' as shown at right.
D Menu resetting (M M - - 1 1 )
If you can't figure out how to return to menu M M - - 1 1 :
While pushing and holding either [Y Y (
[Z Z (
)], turn power ON.
/
MENU
GRP
• The other groups are also reset to S S - - 1 1 or G G - - 1 1 (Scope) at
this time.

■ Initial settings

After resetting the transceiver, set controls and
switches as shown in the diagram below.
CCW : counterclockwise
[AF]: Max. CCW
[POWER]: OFF
[PBT]: Center
(Push and hold for 1 sec.)
Turn power ON, then check the display. If any of the
following indicators appear, turn them OFF as follows:
• Tuning step indicators,
Push [TS].
• MHz tuning step indicator,
Push [TS]
• 1 Hz frequency readout (SSB, CW or RTTY):
Push and hold [TS].
• Preamp indicator,
Push [P.AMP/ATT]
• Attenuator indicator,
Push [P.AMP/ATT]
25
)] and
BAND
)] or
/
MENU
GRP
, (SSB, CW or RTTY):
Z
, (FM, WFM or AM):
Z
:
:
[PWR]
The transceiver's
initial frequency and mode
[PWR]
[MENU/GRP]
• Noise blanker indicator,
Push [NB/ADJ]
• Noise reduction indicator,
Push [NR/LEV]
• Manual notch indicator,
Push [MNF/ADJ]
• Auto notch indicator,
Push [ANF/• REC]
• Memory mode indicator, MEMO:
Use [F-4 V V / / M M ] in the M M - - 2 2 menu (p. 27).
• Split indicator,
:
Use [F-1 S S P P L L ] in the M M - - 1 1 menu (p. 89).
[Y]
[Z]
[RF/SQL]: Center
[PBT/M-ch/RIT]: PBT
(indicator lights)
[LOCK]: OFF
:
:
:
:

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents