Power Requirements; Heat Control Zone Selection - Graco Therm-O-Flow 20 EasyKey NXT 2200 Instructions-Parts List Manual

Overview

Power Requirements

See Table 1, and the Technical Data on page 77.
Table 1: Electrical Requirements
AC Panel
Voltage HZ
240 50/60
380 50/60
480 50/60
ZONE 1
Control
Platen
F

. 2: Heat Control Zone Selection

IG
10
Full Load
Phase Amps
3 36.0
3 17.5
3 18.0
ZONE 2 ZONE 3
Control Control
1250 Watts
max
Pump
Heat Control Zone Selection
The Therm-O-Flow 20 has 6 heat zones (see F
• Zones 1 and 2 are always used for the heated
platen and the heated pump.
• Zones 3 and 4, 5 and 6 are each available as paired
zones through 16-pin connectors.
The heated hoses have a 16-pin connector on the inlet
end cable, and an 8-pin connector on the outlet end
cable. All heated valves, manifolds, and heaters are
equipped with an 8-pin matching connector. Accessory
cables are available for other possible combinations.
Valve 1
Hose 1
ZONE 4 ZONE 5
Control Control
1250 Watts
500 Watts
max
max
Valve 2
Hose 2
ZONE 6
Control
500 Watts
max
TI10092A
. 2).
IG
311976A