Power Requirements; Heat Control Zone Selection - Graco Therm-O-Flow 20 EasyKey Instructions Manual

Overview

Power Requirements

See Table 1, and the Technical Data on page 69.
Table 1: Power Requirements
AC Panel
Voltage HZ
240 50/60
380 50/60
480 50/60

Heat Control Zone Selection

The Therm-O-Flow 20 has 4 heat zones (see F
• Zone 1 is always used for the heated pail platen.
• Zones 2 and 3 are available as paired zones
through 16-pin connectors.
• Zone 4 is not paired, available through a 16-pin con-
nector.
8
Full Load
Phase Amps
3 30
3 14
3 15.2
. 2).
IG
The heated hoses have a 16-pin connector on the inlet
end cable, and an 8-pin connector on the outlet end
cable. All heated valves, manifolds, and heaters are
equipped with an 8-pin matching connector. Accessory
cables are available for other possible combinations.
ZONE 1 ZONE 2
Control Control
1250 Watts
max
Platen
F . 2: Heat Control Zone Selection
IG
Valve 2
Valve 1
Hose 1
ZONE 3 ZONE 4
Control Control
500 Watts 500 Watts
max max
TI10093A
312094K