Cisco 12416 Installation And Configuration Manual page 375
Cisco systems bridge/router installation and configuration guide
Hide thumbs
Also See for Cisco 12416:
- Replacement instructions manual (32 pages) ,
- Unpacking instructions manual (28 pages) ,
- Instructions manual (16 pages)
Table of Contents
Advertisement
Chapter 7
Maintaining the Router
Use the following procedure to remove and replace an alarm card from either the
top or bottom card cage.
Caution
To ensure proper alarm card screw alignment, line card slots adjacent to the alarm
cards must always be populated.
Disconnect any cables from the alarm card.
Step 1
Remove the alarm card:
Step 2
a.
b.
Figure 7-50 Removing an Alarm Card from the Upper Card Cage
a
b
Replace the card by reversing the procedures in Steps 1 and 2.
Step 3
Cisco 12016, Cisco 12416, and Cisco 12816 Router Installation and Configuration Guide
OL-11495-01
Loosen the captive screws at the top and bottom of the front panel
(Figure
7-50a).
Pull the card out of the slot
antistatic bag or other ESD-preventive container.
Loosen
captive
screws
Use handle to pull
card out of slot
Removing and Replacing Cards from the Chassis
(Figure
7-50b) and place it directly into an
7-83
Advertisement
Table of Contents
Troubleshooting
