Cisco 12416 Installation And Configuration Manual page 231

Chapter 4 System Startup and Basic Configuration
Step 2
Copying a Startup Configuration File from a Flash Memory Card to RP NVRAM
Copying a Configuration File from NVRAM to DRAM
OL-11495-01
Enter the dir command to further verify that the configuration file is copied
correctly to the memory card in slot 0:
Milo# dir slot0:
-#- -length- -----date/time------ name
1 5200084 May 10 1997 19:24:12 gsr-p-mz.112-8
3 1215 May 10 1997 20:30:52 myfile1
4 6176844 May 10 1997 23:04:10 gsr-p-mz.112-8.1
5 1186 May 10 1997 16:56:50 myfile2
9197156 bytes available (11381148 bytes used)
Milo#
Enter the copy command in the following form to copy a startup configuration file
from a flash memory card to NVRA.M:
copy [slot0:|slot1:]filename startup-config
Where:
[slot0: | slot1:] specifies the source of the configuration file to be copied.
•
filename is the name of the configuration file to be copied.
•
startup-config specifies the destination (NVRAM) of the file to be copied.
•
Milo# copy slot0:myfile startup-config
[ok]
Milo#
Enter the following command to copy the startup configuration file from NVRAM
to DRAM to designate it as the default running configuration file for the system:
Milo# copy startup-config running-config
Milo#
%SYS-5-CONFIG_I: Configured from memory by console
Milo#
Cisco 12016, Cisco 12416, and Cisco 12816 Router Installation and Configuration Guide
Using RP Flash Memory Cards
4-61