Post-Installation Procedures - Cisco 12416 Installation And Configuration Manual

Chapter 4 System Startup and Basic Configuration

Post-Installation Procedures

OL-11495-01
After you install the router hardware, check all external connections, turn on the
system power, allow the system to boot up, and minimally configure the system,
you may need to perform additional configuration tasks.
The Cisco IOS software running your router contains extensive features and
functionality. For information on Cisco IOS software and general installation and
maintenance information for your router, use the following resources:
For Cisco IOS software configuration information and support, refer to the
•
modular configuration and modular command reference publications. You
can also refer to the Cisco IOS software release notes for the version of
Cisco IOS software you are using on your router.
To access Cisco IOS software documentation and hardware installation
Note
and maintenance documentation, go to http://www.cisco.com.
For information on regulatory compliance and safety, refer to the Regulatory
•
Compliance and Safety Information for Cisco 12000 Series Internet Routers
publication.
For additional line card information, refer to the installation and
•
configuration note for your line card.
For additional GRP information, refer to the configuration note Gigabit Route
•
Processor (GRP) Installation and Configuration Note.
For additional PRP information, refer to the Performance Route Processor
•
(PRP) Installation and Configuration Note.
Cisco 12016, Cisco 12416, and Cisco 12816 Router Installation and Configuration Guide
Post-Installation Procedures
4-63