Cisco 12416 Installation And Configuration Manual page 331

Chapter 7 Maintaining the Router
Install the 2000W PEM
Step 7
a.
To prevent damage to the power shelf backplane connector, do not use excessive
Caution
force when inserting the power supply into its power shelf bay.
b.
c.
If the spring clip does not lock the lever in place, the power supply is not
Caution
completely seated. Eject the power supply and push it in firmly to reseat it.
Cisco 12016, Cisco 12416, and Cisco 12816 Router Installation and Configuration Guide
OL-11495-01
(Figure
Slide the power supply into the bay until it mates with its backplane
connector.
Lift up the ejector lever to hook it over the bottom edge of the power shelf.
Pivot the ejector lever until it is flush with the power supply and the spring
clip locks the lever in place.
Removing and Replacing an AC Power Supply
7-23):
7-39