Attaching Bezel Extenders To The Front Cover - Cisco 12416 Installation And Configuration Manual

Removing and Installing the Front Covers and Bezel Extenders on Original Cisco 12000 Series Routers

Attaching Bezel Extenders to the Front Cover

Step 1
Step 2
Step 3
Caution
Step 4
Caution
Cisco 12016, Cisco 12416, and Cisco 12816 Router Installation and Configuration Guide
7-6
Use the following procedure to attach the bezel extenders to the card cage front
cover.
Remove the front covers from the chassis as described in the
Covers" section on page
Remove the four ball studs from the front cover.
Screw the four ball studs into the threaded holes on the bezel extenders (two ball
studs for each bezel extender) using a wrench to secure them
Do not overtighten the ball studs. Overtightening the ball studs could damage the
threaded hole on the bezel extender.
Attach the bezel extenders to the front cover:
Facing the inside of the front cover, align the screw holes in the left side bezel
a.
extender with the mounting screw holes in the front cover
item 4).
If you cannot align both screw holes on the front cover inserts, you
Note
have the incorrect bezel extender. Try the other bezel extender on this
side.
Fasten the bezel extender to the front cover with the mounting screws
b.
(Figure 7-2, item 2).
Do not overtighten the screws. Overtightening the screws could damage the
threaded holes in the front cover.
c. Repeat Steps a and b to fasten the right side bezel extender to the other side
of the front cover
7-3.
(Figure 7-2, item 4).
Chapter 7 Maintaining the Router
"Removing the Front
(Figure 7-2, item 3).
(Figure 7-2,
OL-11495-01