Cisco 12416 Installation And Configuration Manual page 190

Cisco IOS User Interface
to configure each interface of the system.
Would you like to enter basic management setup? [yes/no]: Yes
Configuring global parameters:
Current interface summary
Interface
Ethernet0
POS1/0
SDCC1/0
POS2/0
SDCC1/0
.
.
.
POS15/0
SDCC15/0
Enter interface name used to connect to the
management network from the above interface summary: Ethernet0
Configuring interface Ethernet0:
Configure IP on this interface? Yes
Class B network is 172.16.0.0, 8 subnet bits; mask is /24
The following configuration command script was created:
hostname Milo
enable secret 5 $1$krIg$emfYm/1OwHVspDuS8Gy0K1
enable password wilma
Cisco 12016, Cisco 12416, and Cisco 12816 Router Installation and Configuration Guide
4-20
Enter host name [Router]: Milo
The enable secret is a password used to protect access to
privileged EXEC and configuration modes. This password, after
entered, becomes encrypted in the configuration.
Enter enable secret [<Use current secret>]: barney
The enable password is used when you do not specify an
enable secret password, with some older software versions, and
some boot images.
Enter enable password: wilma
The virtual terminal password is used to protect
access to the router over a network interface.
Enter virtual terminal password: bambam
Configure SNMP Network Management? [no]:
IP-Address
unassigned
unassigned
unassigned
unassigned
unassigned
unassigned
unassigned
IP address for this interface: 172.16.72.2
Subnet mask for this interface: 255.0.0.0
Chapter 4 System Startup and Basic Configuration
OK? Method Status
YES unset administratively down down
YES unset administratively down down
YES unset administratively down down
YES unset administratively down down
YES unset administratively down down
YES unset administratively down down
YES unset administratively down down
Protocol
OL-11495-01