Cisco 12416 Installation And Configuration Manual page 118

Alarm Card Connection Guidelines
To comply with the intrabuilding lightning surge requirements of
Note
GR-1089-CORE, Issue II, Revision 01, February 1999, you must use a shielded
cable when connecting to the external alarm ports on the alarm card. The shielded
cable is terminated by shielded connectors on both ends, with the cable shield
material tied to both connectors.
Table 2-13
pins and the alarm card relay contacts.
Table 2-13 Alarm Connector Pinout
Pin Group
Critical audible alarm
Major audible alarm
Minor audible alarm
Critical visual alarm
Major visual alarm
Minor visual alarm
Alarm input
Cisco 12016, Cisco 12416, and Cisco 12816 Router Installation and Configuration Guide
2-46
lists the pin-to-signal correspondence between the cable connector
Common
2
16
5
19
8
22
13
Chapter 2 Preparing for Installation
Normally Open Normally Closed
1 14
3 15
4 17
6 18
7 20
9 21
25 —
OL-11495-01