Installation Of The Device - Cisco 910 Series Quick Start Manual

Quick Start Guide for Cisco 910 Industrial Routers

Installation of the Device

Table 3 LED Definition (continued)
No. LED
10 DC-A
11 DC-B
12 SSD
Installation of the Device
You can install the device to a standard DIN rail, or on a wall or a pole by using the IP55 enclosure and wall/pole mount
kit. For detailed installation procedure, see
Before You Begin
Before installing a Cisco 910 Industrial Router, verify that these guidelines are met:
— Sufficient front clearance is available so that the LEDs can be seen.
— Cabling is away from sources of electrical noise, such as radios, power lines, and fluorescent lighting. Make sure
that the cables are safely away from other devices that might damage them.
— Airflow around the device is unrestricted.
— Temperature around the unit does not exceed 70°C.
— Humidity around the device does not exceed 85 percent.
— Altitude at the installation site is below 2000 m.
Warning Statements
Warning: IMPORTANT SAFETY INSTRUCTIONS
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you work on any
equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard practices for
preventing accidents. Use the statement number provided at the end of each warning to locate its translation in the
Single/Dual Color
Color
Dual Off
Solid green
Solid red
Dual Off
Solid green
Solid red
Single Off
Solid green
Blinking green
Mounting Kit Assembly Guide for Cisco 910 Industrial
9
Meaning
Power is not present on the circuit, or the
system is not powered up.
Power is present on the associated circuit and
the router is already booted up.
Power is not present on the associated circuit
and the router is configured for dual-input
power.
Power is not present on the circuit, or the
system is not powered up.
Power is present on the associated circuit and
the router is already booted up.
Power is not present on the associated circuit
and the router is configured for dual-input
power.
No power is provided to SSD.
Power is provided to SSD.
SSD is being accessed.
Router.